Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
32
6.4
OPTIONAL NZ64 BLOWER INSTALLATION
EN
ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE
WITH LOCAL CODES AND WITH THE CURRENT NATIONAL ELECTRIC CODE ANSI/NF NO. 70-CUR-
RENT (IN THE UNITED STATES), OR WITH THE CURRENT CSA C22.1 CANADIAN ELECTRIC CODE (IN
CANADA).
This appliance is supplied with two micro (pressure) switches and a thermally
activated switch. NOTE: The blower on high will draw 3.0 amps using 120V or
approximately 360 Watts.
Ensure that the pressure switch actuating arm protrudes through the faceplate
when installed and moves freely.
The blower will only operate when the doors are fully closed and the air control is
set between "High" and "Low".
Bump
High
Low
Extra Low
MODULATE BLOWER TO SUIT HEAT OUTPUT
W415-1517 / A / 09.02.16
Publicité
Table des Matières
Dépannage
