Battery Replacement - Napoleon GL22N Instructions D'installation Et D'opération

8 .0 M A I N T EN A NCE
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.
APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL APPLIANCE HAS COOLED.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper
and dangerous operation. Verify proper operation after servicing. This appliance and its venting system should
be inspected before use and at least annually by a qualifi ed service person. The appliance area must be
kept clear and free of combustible materials, gasoline or other fl ammable vapours and liquids. The fl ow of
combustion and ventilation air must not be obstructed.
1. In order to properly clean the burner and pilot assembly, remove the logs, rocks and/or glass to
expose both assemblies.
2. Keep the control compartment, media, burner, air shutter opening and the area surrounding the
appliance clean by vacuuming or brushing, at least once a year.
3. Check to see that all burner ports are burning. Clean out any of the ports which may not be burning or
are not burning properly.
4. Check to see that the pilot fl ame is large enough to engulf the fl ame sensor and/or thermocouple /
thermopile as well as reaches the burner.
5. Replace the cleaned logs, rocks or glass. Failure to properly position the media may cause carboning
which can be distributed in the surrounding living area.
6. Check to see that the main burner ignites completely on all openings when turned on. A 5 to 10
second total light-up period is satisfactory. If ignition takes longer, consult your local authorized dealer /
distributor.
7. Visually inspect the appliance for carbon build up. Using a small whisk or brush, brush off the carbon
and vacuum up or sweep into garbage.
8. Check to see that the appliance is venting correctly. Ensure chimney system is safe and unobstructed.
8 .1 BAT T ERY REPLACEMEN T
A. Prior to replacing the battery, turn off the gas manual shut-off valve.
B. Remove the four screws from the battery support plate, as shown.
C. Remove the battery case from the battery support and remove
the 4 (1.5 V) AA size batteries from the battery case and replace
them with the new set of 4 (1.5 V) AA size batteries.
E. Place the battery case back into the battery support.
F. Ensure when installing the battery case that the heat insullation
remains secured to the case.
G. Re-install the battery support plate and secure it using the
2 screws, as shown.
H. Turn the gas shut-off valve back to the on position.
WARNING: Turn the manual shut-off valve to the OFF
position when changing the battery, as shown above.
M A I N T ENA N CE
M A I N T ENA N CE !
MA I N T ENA N CE
DO NOT USE ABRASIVE CLEANERS.
DO NOT PAINT THE PILOT ASSEMBLY.
40.19A
BATTERY
SUPPORT
MANUAL SHUT-OFF
(SHOWN IN OFF POSITI ON)
17
EN
BATTERY
SUPPORT
PLATE
BATTERY
SUPPORT
PLATE
W415-1101 / B / 07.29.13