Wayscral Everyway City 2021 Manuel D'instructions page 21

- The right-hand pedal has a normal thread, screw it in
clockwise with a crank arm.
- The left-hand pedal thread is reversed, screw it in anti-
clockwise.
e) Tension and adjusting the chain
If the bike is equipped with a derailleur, the chain is
automatically tense.
f) Gear operation and adjustment
Your bike is equipped with a 7-gear rear derailleur that can be
manually changed.
Use the right-hand lever to make the desired gear change.
Be sure to shift one gear at a time on the speed selector. When
shifting gear, reduce the force applied to the pedals. It is
recommended to change gears when pedalling slightly.
The higher the number, the harder it is to pedal.
The range of movement of the external derailleur is adjusted
by means of the two derailleur screws H and L:
- the L screw (high stop) adjusts the derailleur position limit
when the chain is on the large sprocket. The tighter it is, the
more limited the derailleur is in its movement.
- the H screw (low stop) adjusts the derailleur position limit
when the chain is on the small sprocket. The tighter it is, the
more limited the derailleur is in its movement.
Adjust by turning the screws clockwise (tighten) or
counterclockwise (loosen), in quarter turns.
For the L screw, turn the screw until the tensioner is perfectly
aligned with the chain and the large sprocket.
For the H screw, turn the screw until the tensioner is perfectly
aligned with the chain and the small sprocket.
The tension of the derailleur cable can be adjusted using the
adjustment knob on the outer derailleur. When it is difficult to
go up in the gears, you need to increase the tension. When it is
difficult to go down, you need to reduce the tension. Then turn
the knob accordingly.
WARNING: For optimal use of the gear change
system, it is recommended that you do not
change gear when you are pedalling hard and
that you switch to the most suitable gear
change combination before stopping to
facilitate restarting.
Attention, never pedal backwards during the
gear change and never force the control lever.
Your bicycle is fitted with front suspension. This device is made
up of cylinders which absorb the shocks.
To adjust the hardness, turn the brown knob on the left side of
the fork until the hardness you have chosen is reached.
You can also lock/unlock the suspension system using the blue
_
knob on the right of the fork.
WARNING: The suspension fork and shock
absorbers must never be removed by the user.
This operation must be performed by a
qualified mechanic.
+
The seatpost has an integrated quick-release system.
Warning: The quick release systems are
release lever.
To adjust, block or unblock the quick release mechanisms:
The lever must show some resistance to opening, for example,
it must not be possible to open the locking mechanism with
one finger.
21/80
g) Suspension adjustment
R
Front view
h) Method for determining the
correct adjustment of the quick
release mechanisms (seat post)
designed to be operated
by hand. Never use
tools to block or
unblock the mechanism
to avoid damaging it. To
adjust the clamping
force, you must use the
adjustment nut located
opposite the lever and
not turn the quick-
L