III.
Recommendations for using the charger
WARNING: Before charging the battery, please read the user manual carefully. Failure to follow the
instructions and safety precautions may result in an electric shock. Keep these instructions in a safe place.
-
Follow the instructions on the battery charger label.
-
Do not use this charger near explosive gases or corrosive substances.
-
Do not shake, knock, or drop the charger.
-
Always protect the charger from rain and humidity; it is for indoor use only.
-
The temperature tolerance of this charger is between 0 and 40°C.
-
You must not dismantle the charger; in the event of a problem, take the device to a qualified repairer.
-
You should only use the charger that came with your electric bike to avoid damage. Note that failure to comply with this constraint will void
the warranty.
-
When charging, the battery and the charger must be at least 10 cm from the wall, in a dry, ventilated and stable place. Do not place anything
in the immediate vicinity of the charger during use. Do not use the charger on an easily flammable surface (e.g., paper, fabric, etc.) or in a
flammable environment. Overheating of the charger may cause a fire.
-
Do not touch the charger for too long during charging (risk of superficial burns).
-
Do not submerge the product.
-
Avoid all contact with water when the battery is charging. Do not touch the charger with wet hands.
-
Check the condition of the charger, cable and connector before each use. Do not use the charger with a damaged power cord or plugs. Make
sure that the charger plug is properly connected to the mains for charging.
-
Do not short-circuit the charger pins by using a metal object.
-
Disconnect the power supply before connecting or disconnecting the connections to the battery.
This charger is not intended for use by children or persons with physical, sensory or mental disabilities or with a lack of experience or knowledge.
This charger may be used by children aged 14 and over and by persons with physical, sensory or mental disabilities or a lack of experience or
knowledge, when under the supervision of a person responsible for their safety or after they have been instructed in the safe use of the charger
and have fully understood the hazards inherent in its use. Otherwise, there is a risk of injury and improper use.
Do not leave children unattended during use, cleaning and maintenance. Make sure that children do not play with the charger.
Only use the charger to charge a lithium battery, never charge any other type of battery. The battery voltage must match the charging voltage of
the charger. Do not recharge a non-rechargeable battery. Otherwise there is a risk of explosion and fire.
Do not expose the charger to rain or moisture. Water entering inside an electric tool increases the risk of electric shock.
Keep the charger clean. Dirt increases the risk of electric shock.
Do not use the charger if you notice any damage. Do not open the charger yourself. Only have it repaired by a qualified technician
using original spare parts.
If the battery is damaged or used improperly, vapours may come out. Ventilate the room and seek medical attention if you feel unwell. The
vapours may irritate your respiratory tracts.
Do not cover the ventilation slots of the charger. Otherwise, the charger may overheat and fail to function properly.
The product's external flexible cable cannot be replaced; if the cord is damaged, the product should be discarded.
At the end of its life, take the product to a recycling centre.
Warning: Protect the springs under the seat if a child seat is installed in order to prevent any risks of fingers
becoming trapped.
IV.
Recommendations for the installation of luggage carriers and child seats
Your bicycle is sold with a luggage rack. Refer to the specifications table for the maximum load.
A child seat can be installed according to the installation instructions of the seat manufacturer.
There are several types of instalments:
-
installing directly on the frame,
-
installing on the luggage rack.
Check that the tightening torques of the screws are correctly followed (refer to the specifications table). In both cases, check that the child seat fits
properly before you set off on your bicycle.
If the seat is changed for a spring-loaded saddle, a child seat can be fitted to the electric bicycle only if the seat springs are protected.
WARNING: your power-assisted bicycle is not designed to pull a trailer.
WARNINGS:
-
Your luggage rack is not designed to pull a trailer.
-
For safety reasons, only luggage must be carried on the luggage rack.
-
When the luggage rack is loaded, the bearing of your bicycle changes (particularly steering and braking).
Spread the luggage load equally on both sides to help keep your bicycle stable.
25/80