Cub Cadet XR2 1000 Manuel Utilisateur page 40

Troubleshooting
Message Probable
Displayed Cause / Event
StOP
The mower got stuck in
place. It cannot continue
(Stuck in place)
driving.
Out The Perimeter Wire is
too close to the edge.
(Crossed outside)
The lawn slope near
the edge is too big and
causes the mower to slip
outside.
The lawn's edge is too
bumpy.
LOOP The Power Supply is
unplugged or there is a
(No wire signal)
temporary power cut.
Signal generator may
need to be restarted.
Waiting for the perimeter
signal.
The Perimeter Wire is cut.
ELEC There is a temporary
power cut.
(Check power)
The Power Supply is not
plugged in properly.
There is no charging
source detected.
78
Corrective
Action
Check the ground for holes or
indentations. Fill it with some earth.
Check if the Perimeter Wire is not
too close to the edge. Move the wire
towards the inner side of the lawn.
Move the wire towards the inner side
of the lawn.
Do not include areas with very steep
slopes.
Fill holes and pits along the edge till
level with the ground.
Make sure the Power Supply is
connected to the mains supply.
Disconnect the Power Supply from the
mains supply and reconnect after 10
seconds.
Check all power cable connections.
The mower will resume automatically.
Check for cuts in the Perimeter
Wire.
Check main power supply to the
Power Supply.
Confirm the Power Supply is plugged in.
Clean the charging contacts on the
Base Station and verify proper
connection of the Base Station to the
Power Supply.
Message Probable
Displayed Cause / Event
LOAd The mowing system is
in overload due to very
(Check mowing
tall grass or an obstacle
height)
that is stuck or wrapped
around the blade.
HrS Too many Inactive Days
and/or Hours have been
(Decrease
set for your lawn
inactive time)
area.
Mowing Frequency is too
high for current settings
of Inactive Time.
Area setting is too high
for current settings of
Inactive Time.
SEnd Wait for the operational
data to be sent via the
(Sending
GSM module.
operational data)
LIFt Switch off before lifting.
(Lift detected)
OFF
The mower is
connected to charging,
(Switched off)
but switched off.
HEAt The mowing motor has
been overloaded for too
(Overheat)
long.
Corrective
Action
Switch off the Safety Switch and
inspect the blades. Remove any
foreign object or excessive clogging
inside the mowing deck.
Raise the mowing height and switch
the TurboMode on.
Decrease the number of Inactive Days
and/or the number of Inactive Hours.
Decrease Mowing
Frequency. See "Tell your mower how
often to mow".
Decrease area setting.
No action is required. As soon as
the operational data has been sent,
charging will start. This may take a
couple of minutes.
It is required to switch Off the System
Switch before lifting and carrying the
mower.
Switch the System Switch to 'On' to
allow charging.
No action required. The mower will
resume automatically once cooled
down.
79