Cub Cadet XR2 1000 Manuel Utilisateur page 32

Setting Description
P017 Mobile Communication System
Enable GSM module accessory (if installed).
P018 Statistics On/Off
Send operating statistics for diagnostics.
P019 Bluetooth Remote Control Pairing
Pair Remote Control accessory with your mower.
P020 Last Termination Event
Enable special debug mode (by a Service Station).
P021 Program On/Off
Enable/Disable automatic operation by zone.
See section 4 further.
P022 Add Sub-Zone
Start the process of adding a sub-zone.
Refer to the"Adding Sub Zones" section of the Installation Manual.
P023 Update Distance to Sub-Zone
Update the distance to the Sub-Zone's entry point.
This menu option is only shown if a Sub-Zone is defined.
P024 SmartMow On/Off
Increase mowing efficiency.
May be less efficient with particular lawn shapes.
P025 SmartMow Edge Overlap
Optimize SmartMow mode for your lawn.
P026 Turbo Mow On/Off
Enable faster and stronger cut. When the mowing cycle is
completed, this feature is set to off automatically.
P027 RoboHome On/Off
Allow proper rain detection when RoboHome is installed.
P028 External Base
Enable and set the distance of an external base installation.
(*) This setting is not applicable to models for lawns under 800 m
62
/8600 ft .
2 2
Setting Description
P029 Collision Detection Sensitivity
Set a higher value for a softer collision with objects. May cause
false-detections.
P030 Energy Saver
Minimize power consumption and disable automatic operation
to comply with CEC/DoE regulation. Appears only when Program
is set to Off.
P031 Signal Type
Change it to avoid interference with other robotic mowers
around. Must be done inside the Base Station.
63