Table des Matières
Publicité
GB-F-NL-58
Fig.37
Fig.38
Fig.39
The cutting height is determined by the position of the
blades in relation to the caster wheels. Changes to
this height are made at (4) points and can be made in
any order. For the following procedure, refer to the
Height of Cut chart below.
NOTE - Cutting height must be set the same for all
three decks
HEIGHT OF CUT (Fig.37 / 38)
1. Remove the quick pin Q from the top of the
caster wheel pivot spindle
2. Remove the caster wheel.
3. Check to see if the wheel mounting bracket M is
in the required position. If not, remove (4)
mounting bolts R and move to correct location
and bolt in place.
4. Place the required number of spacers S below
the wheel mounting bracket and place the
balance of the spacers above the wheel
mounting bracket.
5. Replace the quick pin.
6. Place pin P into proper hole for height of cut
according to the chart.
CUTTER DECK BELT TENSION (Fig.39)
Check all belts regularly during the first 5, 10 and 15
hours of operation, and then after every 50 hours of
operation. If necessary adjust as follows:
1. Adjust belt tension to 1/2" (13 mm) deflection at
10 lbs (5 kg) force at the middle of the long rear
span D. If necessary, adjust as follows:
2. Loosen locking nut on adjustment bolt E.
3. Loosen (4) bolts G fastening the motor mounting
plate to the cutter deck (3 visible in photo).
4. Turn adjustment bolt E until proper tension is
obtained.
5. Retighten (4) bolts G and lock nut on adjustment
bolt E.
GB
Publicité
Table des Matières
