Engine Oil; Idle Speed Adjustment - Suzuki LT-F160K4 Manuel D'assemblage

ENGINE OIL VISCOSITY RATING SELECTION CHART
TABLEAU DE SELECTIONS DE VISCOSITE D'HUILE MOTEUR

ENGINE OIL

HUILE-MOTEUR
TEMP.
ENGINE OIL
!
This vehicle is shipped from factory with the
engine filled with engine oil. Be sure to check
oil level.
Check the engine oil level through the engine oil
inspection window with the vehicle held vertically on
level ground. Start the engine and allow it to run for a
few minutes at idling speed. Turn off the engine and
wait about three minutes, then check the oil level
through the inspection window. If the level is below
the "L" mark, add oil to "F" level. If the level is above
the "F" mark, drain oil to "F" level.
Replace the drain plug and engine oil filler plug.
Tighten them securely.
A: Engine oil filler plug
B: Engine oil level inspection window
NOTE:
Use a premium quality 4-stroke motor oil to
ensure longer service life of the vehicle. Use
only oils which are rated SF or SG under the
API service classification. The recommended
viscosity is SAE 10W-40. If an SAE 10W-40
motor oil is not available, select alternative
according to the left chart. If the vehicle is
used in very cold weather (below –15°C (5°F)),
use SAE 5W-30 for good engine starting and
smooth operation.
Test ride the vehicle checking all mechanical func-
tions. Tighten all nuts, bolts and miscellaneous
mounting parts to the proper torque specs.
Confirm that all cables and wiring harnesses are con-
nected and routed correctly.

IDLE SPEED ADJUSTMENT

After completing all of the servicing procedures and
the test ride, adjust the engine idle speed by turning
the throttle stop screw.
NOTE:
The engine idle should be adjusted with
engine warmed up.
Engine idle speed: 1 450–1 550 r/min
A: Throttle stop screw
43