Headlight Beam Adjustment; Engine Oil - Suzuki LT-F400K3 Manuel D'assemblage

HEADLIGHT BEAM ADJUSTMENT

The headlight beam can be adjusted vertically if nec-
essary.
To adjust the beam vertically:
Move the headlight up and down by hand.

ENGINE OIL

Pull the fasteners.
Remove the cover.
A: Cover
B: Boss
C: Fasteners
!
This vehicle is shipped from factory with the
engine filled with engine oil. Be sure to check
oil level.
Check the engine oil level with the engine oil dipstick.
Place the vehicle on level ground. Start the engine
and allow it to run for a few minutes at idling speed.
Stop the engine and wait about three minutes.
F F
Remove the oil filler plug. The engine oil dipstick
L L
comes out together with the oil filler plug.
Wipe the oil from the dipstick with a clean rag.
Holding the vehicle vertically, reinsert the dipstick
until the threads touch the filler neck, but do not
screw the plug in.
Draw out the dipstick and check the oil level. The
level found on the dipstick should be between "L"
(Low) and "F" (Full) line. If the oil level is below the "L"
line, add fresh oil from the filler hole until the oil level
reaches to "F" line.If the level is above the "F" line,
drain oil to "F" line.Replace the drain plug and engine
oil filler plug tighten it securely.
Reinstall the cover. Push the fasteners.
A: Engine oil filler plug
B: Engine oil dipstick
27