Front Wheel - Suzuki LT-F160K4 Manuel D'assemblage

FRONT
AVANT
FRONT
AVANT
FRONT SHOCK ABSORBER
Install the lower part of front shock absorbers with
bolts and nuts.
Tighten the front shock absorber nuts to the specified
torque.
" " Front shock absorber nut: 50 N·m (5.0 kgf-m)
" "
#
Make sure that both the upper mounting bolts
and lower mounting bolts and nuts are tight-
ened with specified torque.
A: Front shock absorber
B: 10 × 40 mm "7" marked flange bolt
C: 10 mm flange self-lock nut
D: Bracket

FRONT WHEEL

Carefully clean the front wheel hubs and drums with a
cloth to remove all dust.
When installing the front wheels onto the axles, spe-
cial attention must be paid to the arrow of the rota-
tional direction on the tire sidewall. When the tires are
properly installed, the arrows must indicate forward
rotation of the wheels.
Properly position the wheel on the axle stud bolts,
then attach the washer to each of the stud bolts.
NOTE:
Be sure to install the front wheels with the air
valves facing outwards.
Temporarily tighten the wheel set nuts, then remove
the hoist used to lift the vehicle.
A: Stud bolt
B: Air valve
C: Wheel set nut (8 mm flange nut)
D: Washer OD: 16.0 mm ID: 8.5 mm
19