Suzuki LT-F160K4 Manuel D'assemblage page 16

LEFT SWITCH
Remove the screws holding the left switch housing.
Insert the choke cable into the hole of lower housing.
A: Screw
B: Lower housing
C: Choke cable end
Insert the choke cable end into the recess in the
choke lever.
Insert the boss of upper housing into the hole on the
handlebars.
Install the left switch lower housing and tighten the
left switch assembly with the two screws. Fasten the
choke cable holder on the front screw.
A: Cable end
B: Boss
C: Hole
Put the rubber boot to the choke lever and cover the
brim of the upper and lower housing with the rubber
boot.
A: Choke lever
B: Rubber boot
CLAMP
Clamp the left switch wiring harness and handlebar
with strap.
A: Strap
B: Left switch wiring harness
15
D: 5 × 40 mm screw
E: 5 × 45 mm screw
F: Cable holder