HANDLEBAR
Pass the ignition switch, left switch, front brake switch
and indicator light wiring harnesses to the right side
of the boss on the handlebar mounting bracket.
NOTE:
Do not pass the choke cable.
A: Left switch wiring harness
B: Ignition switch wiring harness
C: Indicator light lead wire
D: Choke cable
E: Front brake switch lead wire
F: Boss
Install the handlebar to the handlebar mounting
bracket as shown in the illustration.
NOTE:
Install the headlight bracket together with bolt
at front side.
Install the ignition switch bracket together
with bolt at rear side.
!
Pass the ignition switch, left switch, front
brake switch and indicator light wiring har-
nesses between the handlebar and handlebar
mounting bracket.
A: Handlebar clamp
B: Handlebar mounting bracket
C: 8 × 55 mm bolt (with lock washer)
D: Headlight bracket
E: Ignition switch bracket
F: Wiring harness
G: Dot mark
Tighten the handlebar clamp bolts to the specified
torque.
NOTE:
Align the dot mark on the handlebars with the
mating surface of the rear side of left clamp.
!
Make sure each clamp, as bolted, is true and
square, with the clearances equalized as
shown.
"
" Handlebar clamp bolt: 23 N·m (2.3 kgf-m)
"
"
Tighten the headlight bracket bolts.
A: 8 × 55 mm bolt (with lock washer)
B: Dot mark
C: 8 × 16 mm bolt (with lock washer and washer)
7