Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. SETTINGS VIA CIRCUIT BOARD CONTROLLER
6.1. ADJUSTING THE WATER TEMPERATURE
The unit starts from the set temperature
6.1.1. Setting the maximum water temperature for cooling
By setting the temperature lower, the unit will start later. If the water temperature is set higher, the unit
will start faster .
1. Start setup mode: hold the [-] button until the
2.
1
-
The blue LED flashes quickly
minimum temperature is reached.
Automatic control:
set temperature
3. Exit setup mode: hold the [-] button until the
6.1.2. set minimum water temperature heating
By setting the temperature higher, the unit will start later. If the water temperature is set lower, the
unit will start faster .
When using a heat pump, it may be necessary to set the water temperature at a lower setting .
1. Exit setup mode: hold the [+] button until the
2.
1
-
The blue LED flashes quickly
minimum temperature is reached.
Automatic control:
temperature .
3. Exit setup mode: hold the [+] button until the
After 30 seconds, the new settings are automatically saved and the device returns to the
selected mode. .
/
24
28
blue LED
Briefly press the [-] or [+] button to adjust the set tempe-
12 ̊ C
14 ̊ C
16 ̊ C
18 ̊ C
as soon as the
.
The green LED
lights up when the water temperature (supply water) is lower than the
blue LED
red LED
Briefly press the [-] or [+] button to adjust the set tempe-
rature .
24 ̊ C
26 ̊ C
28 ̊ C
30 ̊ C
as soon as the
.
The green LED
lights when the water temperature (supply water) exceeds the set
red LED
.
flashes 5x and release .
rature .
20 ̊ C
22 ̊ C
24 ̊ C
The red LED flashes quickly
maximum temperature is reached.
flashes 5x and release .
flashes 5x and release .
32 ̊ C
34 ̊ C
36 ̊ C
The red LED flashes quickly
maximum temperature is reached.
flashes 5x and release .
1
-
26 ̊ C
as soon
as
the
.
1
-
38 ̊ C
as soon
as
the
.
EN
107
Publicité
Table des Matières
