Auto-Change-Over - Jaga DBH SET Manuel

D. AUTO-CHANGE-OVER
Only in combination with a suitable heat
pump and thermostat head for heating
and cooling
2⁰C
This device is not equipped with dew point control. This must be installed in the most critical place
by the installer! Condensing cooling due to a dew point control malfunction may damage the device
and its surroundings. !
The device automatically enters the cooling mode as soon as the water temperature is 2
than the room temperature. If the water temperature is less than 1
the device will automatically switch to standby.
The unit is in standby. The unit automatically starts a new cycle as soon as the set temperature
has been reached.
The device automatically enters the heating mode as soon as the water temperature is 4
than the room temperature. If the water temperature is less than 1
re, the device will automatically switch to standby.
De breeze mode is switched on and off manually. The auto-change-over is disabled as long as the
breeze mode is active. Only applicable with control panel!
Configuration code : DPC.HCB120 / DPC.HCB320 / DPC.HCB423 / DPC.HCB623
MODE
ONLY DPC.HCB423 /
DPC.HCB623
1
Option:
Thermo-electrical motor
102
1⁰C
Standby mode
[B]
1⁰C
°
C lower than the room temperature,
° C higher than the room temperatu-
Option
4⁰C
°
C lower
°
C higher