Notifications; Factory Reset - Jaga DBH SET Manuel

7. NOTIFICATIONS
Blue LEDs are flashing in the set mode: the
water temperature of the supplied water is too
high (Tw > 24 ̊ C ). .
MODE
MODE
MODE
The LEDs are blinking in a pattern and in the color that matches the selected mode
Only if the window contact is connecrted and switched on : The window contact is open .
MODE MODE MODE
Circuit board error code
1
Control panel error codes
LED flashes rapidly in the color of the set mode .
MODE MODE
MODE MODE
8. FACTORY RESET
1. Disable power charge .
2. Press and hold down both the [-] and [+] button on the circuit board
and switch on the power again. The
by the green LED 2 seconds later and the
Release the buttons as soon as all 3 LEDs are flashing .
3. The controller will return to the Factory settings, all LEDs will flash for 10 seconds. The controller
will return to the Factory Default settings, all LEDs will flash for 8 seconds .
Red LEDs are flashing in the set mode: the water
temperature of the supplied water is too low (Tw
< 28 ̊ C ). .
MODE MODE MODE
Error sensor [3] - Check the water temperature sensor
Error sensor [4] - Check the room temperature sensor
blue LED will light up, followed
red LED 4 seconds later.
MODE
MODE
MODE
Error sensor [3] - Check the water tempe-
rature sensor
Error sensor [4] - Check the room tempe-
rature sensor
1
MODE MODE MODE
EN
-
109