Notifications; Settings; Setting Fanspeed - Jaga FREEDOM Manuel D'utilisation

Switch off the device : Hold down [Mode] until all LEDs are off.
MODE
10 sec
5.1. NOTIFICATIONS
Blue LEDs are flashing: the water temperature for cooling is too high
Red LEDs are flashing: the water temperature for heating is too low
Control panel error codes
MODE MODE
6. SETTINGS
6.1. SETTING FANSPEED
1. Select the mode that you want to adjust : Cooling
2. Select the speed that you want to adjust :
3. Hold down [Mode] and [-] simultaneously until the first 4 LED's are flashing .
4. Short press [-] or [+] to adjust the preset speed .
25%
30%
35%
40%
45%
50%
55%
60%
5. After 30 seconds, the new settings are automatically saved and the device returns to the selected
mode. .
FREEDOM | MANUAL | 2021.06.07 | V.02
MODE
Check the water temperature sensor
15 sec
MODE MODE
MODE MODE
MODE MODE
MODE MODE
MODE MODE
MODE MODE
MODE
MODE
MODE MODE
MODE
/ breeze / Heating
MODE
MODE MODE
MODE MODE
MODE MODE
MODE MODE
MODE MODE
MODE MODE
MODE MODE
MODE MODE
MODE
EN
65%
70%
75%
80%
85%
90%
95%
100%
29