B 3 . 0 - 10V Bms With Water- And Room Temperature Monitoring (Auto-Change-Over) - Jaga DBH SET Manuel

B 3 . 0 - 10V BMS WITH WATER- AND ROOM TEMPERATURE MONITORING
(AUTO-CHANGE-OVER)
Configuration code : DPC.HC6320 / DPC.HC6623
Only in combination with a suitable heat
pump and thermostat head for heating
and cooling
2⁰C
The device automatically enters the cooling mode as soon as the water temperature is 2
than the room temperature. If the water temperature is less than 1
the device will automatically switch to standby.
The unit is in standby.
The device automatically enters the heating mode as soon as the water temperature is 4
than the room temperature. If the water temperature is less than 1
re, the device will automatically switch to standby.
MODE
ONLY DPC.HC6623
B3.1. FACTORY SETTINGS
B3.1.1. Without control panel
.The control is set by default to auto-change-over mode. In this mode, the device itself
controls the desired operating mode based on the water and room temperature .
Auto-change-over. The unit starts as soon as the water temperature > 28 ̊ C .
96
1⁰C
Standby mode
1
- DPC.HC6320
1⁰C
°
C lower than the room temperature,
° C higher than the room temperatu-
[6]
4⁰C
°
C lower
° C higher