Beper BC.130 Mode D'emploi page 12

Bread Maker Use instructions
Loaf size button
With this button you can select the size of the loaf. Please note the total operation time may vary with the different
loaf size selected. This button is not applicable for the program "Quick", "Dough", "Jam", "Cake" and "Bake".
Delay function
It is possible to start the appliance in a certain time of the day.
Set the machine with the desired programs, before switch on the appliance move the arrows up and down to
increase the time. When the display will show the time you want the bread get ready.
Example: Now it is 8:30p.m, if you would like your bread to be ready in the next morning at 7 o'clock, i.e. in 10
hours and 30 minutes. Select your menu, colour, loaf size then press the "+" or "–" to add the time until 10:30
appears on the LCD.
The increment is of 10 minutes each touch. The maximum delay is 13 hours.
At this point press the STOP/START button to activate this delay program.
You can see on the LCD will count down to show the remaining time.
If you don't take out the bread immediately at the end of the process, the "keeping warm" function of 60 minutes
activate automatically.
This function is not applicable for the programs "Ultra fast", "Jam" and "Bake".
When use this function, do not add any easily perishable ingredients such as eggs, fresh milk, fruits, onions, etc.
Keep warm function
Bread can be automatically kept warm for 60 minutes after baking. If you would like to take the bread out, switch
the program off with the START/STOP button.
Memory
If the power supply will be broken off during the course of bread making, the process of bread making will be
continued automatically within 10 minutes, even without pressing Start/stop button. If the break time exceeds 10
minutes the memory cannot be kept and the bread maker must be restarted.
Environment
To get better results of baking and rinsing it is suggested to use the appliance in a room with temperature betwe-
en 15 °C and 34°C.
Warning on display
HHH: if during use on the display will show this message accompanied by 5 beep sounds, it means that the
temperature inside the machine is too high. Stop the program ,open the lid and let the machine cool down for
10 - 20 minutes.
EE0: : if during use on the display will show this message means that the temperature sensor is out of order.
Please contact after sales service.
First use
After removing all packing material please check if all parts and accessories are complete and free of damage
and clean as described in the section "Cleaning and Maintenance"
Set the bread maker in baking mode and bake empty for about 10 minutes. After it cool down clean once more.
At this point the appliance is ready for using.
How to make bread
Place the pan in position and turn it clockwise until it clicks in correct position. Put the kneading blade onto the
drive shaft. Before installing the kneading blade it is recommended to grease it with some butter, this avoids the
dough to stick below the kneaders and the kneaders could be removed from bread easily.
Place ingredients into the bread pan, keep the order mentioned in the recipe. Usually the water or liquid substan-
ce should be put firstly, then add sugar, salt and flour, always add yeast as the last ingredient.
Attention: the maximum quantity of the flour is 590g.
With finger make a small indentation on one side of the flour. Add yeast to indentation, make sure it does not
come into contact with the salt.
Close the lid gently and plug the power cord into a wall outlet.
Press the Menu button until your desired program is selected.
12