TLV JH-P Série Manuel D'utilisation page 11

Disassembly / Reassembly (to reassemble, follow procedures in reverse)
JH5RL-P JH7RM-P
Part & No.
JH5RH-P JH7.2R-P
Drain Plug 19
*
Drain Plug
*
Gasket 18
Cover Nut 12
Cover 2
Cover Gasket 13
Cover Plug 14
Cover Plug
Gasket 15
Plug (Interior) 25
Plug Gasket
(Interior) 26
Snap Ring 23
Screen 9 &
Float Cover 8
Screen 9
Screen Holder
Retainer 24
Screen Holder 17
Float 3
Orifice Plug 6
Orifice Plug
Gasket 7
Outlet Cover
Nut 22
Outlet Cover 6
Outlet Cover
Gasket 7
Orifice
Locknut 20
Orifice 4
Orifice Gasket 5
* Option
** Must remove Plug (Interior) 25 (JH7.5R-P, JH8R-P only) before this part can be removed or inserted
During Disassembly
JH7RH-P JH7.5R-P JH8R-P
Use a wrench to remove
Remove gasket and
clean sealing surfaces
Use a wrench to remove
Remove (use all 4 eye bolts
for JH8R-P to hoist the cover)
Remove gasket and clean
sealing surfaces
Use a wrench to remove
Remove gasket and clean
sealing surfaces
Use a wrench to remove
Remove gasket and clean
sealing surfaces
** ** Use appropriate pliers
Lift straight up
Lift straight up while turning
Lift straight up
** **
** ** Remove without bending
Remove, careful not to
** **
scratch grounded surface
Use a wrench to remove
Remove gasket and clean
sealing surfaces
Use a wrench to remove
Remove
Remove gasket and clean
sealing surfaces
Use a wrench to remove
(may require extension bar)
Use a wrench to remove
Remove from interior
Remove gasket and clean
sealing surfaces
̶ 10 ̶
During Reassembly
Coat threads with anti-seize
and tighten to the proper
torque
Replace with a new gasket,
coat surfaces with anti-seize
Coat threads with anti-seize
and tighten to the proper
torque
Align cover with the connector
or the arrow on the body and
attach
Replace with a new gasket, do
not apply anti-seize
Coat threads with anti-seize
and tighten to the proper
torque
Replace with a new gasket,
coat surfaces with anti-seize
Coat threads with anti-seize
and tighten to the proper torque
Replace with a new gasket,
coat surfaces with anti-seize
Insert securely into groove
Align arrows and insert, insert
tab on bottom into guide on
body and push in until top is
flush
Place screen holder on ledge
inside body, round side up;
place screen holder retainer
next (if applicable), followed by
screen
Insert into body, being careful
not to scratch its grounded
surface
Coat threads with anti-seize
and tighten to the proper
torque
Replace with a new gasket,
coat surfaces with anti-seize
Coat threads with anti-seize
and tighten to the proper
torque
Attach
Replace with a new gasket, do
not apply anti-seize
Coat threads with anti-seize
and tighten to the proper
torque (see page 12)
Coat threads with anti-seize
and tighten to the proper
torque
Fix with Orifice Locknut
(see page 12)
Replace with a new gasket,
coat surfaces with anti-seize
Replace with a new gasket
(see page 12)