Publicité
Special accessories
13.3 Room climate control station
With cooling using panel heating/cooling systems, regulation is
carried out according to the room temperature and humidity
measured by the room climate control station.
This is done by setting the desired room temperature on the heat
pump
manager.
The
minimum
temperature is calculated from the room temperature and
humidity measured in the reference room. The control response
of the cooling system is influenced by the currently measured
room temperature and the set room set temperature.
13.4 Building management technology
The heat pump manager can be connected to a building
management system network via supplementation of the
relevant interface plug-in card. The supplementary installation
instructions of the interface card must be consulted regarding the
exact connection and parameterisation of the interface.
13.5 Thermal energy meter
A maximum of 2 thermal energy meters can be connected to the
heat pump manager for thermal energy measurement. Available
thermal energy meters are the WMZ25 and the WMZ32. The
supplementary installation instructions of the thermal energy
meter must be consulted regarding its installation and
parameterisation.
possible
cooling
water
Fig. 13.1: Room climate control station
The following networkconnections are possible with the heat
pump manager:
Modbus
EIB, KNX
Ethernet
13.5
EN-37
Publicité
Chapitres
