5 Basic Settings And Reset; 6 Setting The Transmission Frequency; 6 1 Remoset Function - Monacor International JTS JSS-4B/5 Mode D'emploi

5) To save a setting, press the button SET The
display briefly indicates
main menu reappears
To exit a menu item without a change,
press the button
reappears
6) To exit the main menu, press the button
press the button  or  to select the menu
item and then press the button SET
Exit
All setting options via the menu can be found
in the following chapters

3.5 Basic settings and reset

1) If it is difficult to read the display, call up
the contrast setting via the menu item
:
8. Contrast
LCD Contrast
10
Press the button  or  to set the con­
trast The display indicates the value adjusted
between 0 and 20 Press the button SET to
save the setting The main menu reappears
To deactivate the main menu, press the
button or to change another setting, press
the button  or  to select the correspond­
ing menu item and press the button SET
2) To set the time for the display backlight, go
to the menu item
Light Time
15 Sec.
= no backlight
Always OFF
– = time in seconds
5 30 Sec.
= backlight always on
Always ON
Hint: To save the batteries, it is advisable not to use
as a permanent setting
Always ON
3) For a reset to the factory settings, select the
menu item
c. Reset
SET A message appears to warn you that
resetting will erase any data stored:
This will erase
all data from Mic
Internal Storage.
Yes/No
To cancel the process, retain the option
and press the button SET; to reset, use the
button  to select
ton SET
before the
Saving
(9) The main menu
Fig. 4
:
9. Light Time
Fig. 5
and press the button
Fig. 6
and press the but­
Yes

3.6 Setting the transmission frequency

Before switching on the microphone, set the
receiver to an interference­free frequency (refer
to the instruction manual of the receiver) Then
set the microphone to the same frequency
There are three methods to do this:
or
1 If you operate the microphone together with
the receiver R­4 / 5, the easiest way is to use
the patented REMOSET function When you
press the button REMOSET on the receiver,
the microphone is set to the transmission
frequency selected on the receiver (chapter
3 6 1)
2 The transmission frequency can be ad­
justed manually between 506 000 MHz and
542 000 MHz (chapter 3 6 2)
3 For operating multiple wireless microphones
at the same time, there are 6 groups with up
to 22 channels in each group (refer to the
table on page 19) In ideal conditions, all
channels from a group can be used for audio
transmission at the same time If the receiver
has been set to a channel from these groups,
select the same channel for the microphone
(chapter 3 6 3)
3.6.1 REMOSET function
For the REMOSET function always make sure
that
1 no menu is called up on the microphone or
on the receiver
2 the microphone is switched on and close to
the receiver (REMOSET transmission range:
approx 10 m)
3 the microphone and the receiver are set to
the same identification number (ID No ) or
that the function ID No is deactivated (see
paragraph "Identification number")
4 the REMOSET function is not disabled (see
paragraph "Disabling the REMOSET func­
tion")
No
15