5 Basic Settings And Reset; 6 Setting The Transmission Frequency - Monacor International JTS JSS-20/5 Mode D'emploi

5) To save a setting, press the button SET The
display briefly indicates
main menu reappears
To exit a menu item without a change,
press the button
reappears
6) To exit the main menu, press the button
press the button  or  to select the menu
item and then press the button SET
Exit
All setting options via the menu can be found
in the following chapters

3.5 Basic settings and reset

1) If it is difficult to read the display, call up
the contrast setting via the menu item
:
8. Contrast
LCD Contrast
10
Press the button  or  to set the con­
trast The display indicates the value adjusted
between 0 and 20 Press the button SET to
save the setting The main menu reappears
To deactivate the main menu, press the
button or to change another setting, press
the button  or  to select the correspond­
ing menu item and press the button SET
2) To set the time for the display backlight, go
to the menu item
Light Time
15 Sec.
= no backlight
Always OFF
– = time in seconds
5 30 Sec.
= backlight always on
Always ON
Hint: To save the batteries, it is advisable not to use
as a permanent setting
Always ON
3) Via the menu item
name can be entered (10 characters max )
which appears on the display (e g JSS­20
as shown in Fig 2) When multiple micro­
phones are used, this will make it easier to
distinguish between the microphones and to
identify them After the menu item
has been called up, the first character
Name
position is selected:
before the
Saving
(9) The main menu
Fig. 4
:
9. Light Time
Fig. 5
, a device
a. User Name
a. User
User Name
J SS-20
Char:1/10
Press the button  or  to select the de­
sired character Press the button SET to go
to the next character position After setting
or
the name, press the button SET repeatedly
until the display indicates
menu reappears
4) For a reset to the factory settings, select the
menu item
SET A message appears to warn you that
resetting will erase any data stored:
This will erase
all data from Mic
Internal Storage.
Yes/No
To cancel the process, retain the option
and press the button SET; to reset, use the
button  to select
ton SET

3.6 Setting the transmission frequency

Before switching on the microphone, set the
receiver to an interference­free frequency (refer
to the instruction manual of the receiver) Then
set the microphone to the same frequency:
There are three methods to do this:
1 If you operate the microphone together with
the receiver UF­20R / 5 or UF­20S / 5, the easi­
est way is to use the patented REMOSET func­
tion When you press the button REMOSET
on the receiver, the microphone is set to the
transmission frequency selected on the re­
ceiver (chapter 3 6 1)
2 The transmission frequency can be ad­
justed manually between 530 000 MHz and
605 000 MHz (chapter 3 6 2)
3 For operating multiple audio transmission sys­
tems at the same time, there are 15 groups
with up to 63 channels in each group (refer
to the table starting on page 38) In ideal
conditions, all channels from a group can be
used for audio transmission at the same time
If the receiver has been set to a channel from
these groups, select the same channel for the
microphone (chapter 3 6 3)
Fig. 6
Saving
and press the button
c. Reset
Fig. 7
and press the but­
Yes
The main
No
15