8 Adjusting The Microphone Sensitivity; 9 Low-Cut Filter; 10 Muting The Microphone - Monacor International JTS JSS-4B/5 Mode D'emploi

= low power (10 mW): long battery
Low
life, but short range
3) Press the button SET to save the setting
Note: The setting
RF Power
on the receiver R­4 / 5 via the REMOSET function (refer
to the instruction manual of the receiver)
3.8 Adjusting the
microphone sensitivity
The sensitivity adjustment is used to match the
microphone to the volume of the voice or the
instrument
1) Call up the menu item
Sensitivity
0 dB
2) Adjust the sensitivity according to the indi­
cation AF of the receiver in such a way that
an optimum signal level is obtained If the
sensitivity is too high, the microphone signal
will distort; in this case, press the button  to
set a lower value (min −15 dB) If the volume
is too low, there will be a poor signal­to­noise
ratio; in this case, press the button  to set
a higher value (max +15 dB)
3) Press the button SET to save the setting
Note: The setting
Sensitivity
directly on the receiver R­4 / 5 via the REMOSET function
(refer to the instruction manual of the receiver)

3.9 Low-cut filter

To suppress low frequencies (e g impact sound,
rumble), a low­cut filter (80 Hz) can be activated
1) Call up the menu item
LOW CUT
ON
2) Press the button  to activate the filter (ON,
symbol ) or press the button  to deacti­
vate the filter (OFF, symbol
3) Press the button SET to save the setting
Note:
In the setting
Low Cut ON
tivated, the symbol
indication
can also be made directly
3. Sensitivity
Fig. 12
can also be made
L ow Cut
4.
Fig. 13
)
, when the menu is deac­
appears on the display as an

3.10 Muting the microphone

To briefly mute the microphone, e g in speech/
music pauses, briefly press the button
LED (3) keeps flashing in red and the display
periodically indicates
of the receiver R­4 / 5 periodically indicates the
message
Mic. Mute
button once again
Note: When the keys are locked (chapter 3 11), the
muting function is locked as well
3.11 Key lock
The microphone is provided with a key lock to
prevent inadvertent switch­off or operation
– Activating the lock –
1) Call up the lock function via the menu item
d. KeyLock
KeyLock
ON
OFF
2) Press the button  to activate the key lock
(ON)
3) Press the button SET to save the setting
When a button is pressed, the following mes­
sage appears:
Press Set for
2 Sec. to
unlock keypad.
Notes:
1 When the key lock is activated and the menu is
deactivated, the symbol
2 The key lock can also be activated or deactivated
directly on the receiver R­4 / 5 via the REMOSET func­
tion (refer to the instruction manual of the receiver)
– Deactivating the lock –
1) Keep the button SET pressed for two seconds
until the menu
KeyLock
KeyLock
ON
OFF
2) Press the button  to select the setting
and press the button SET to save the setting
(9) The
The display
Mute ON
To unmute, press the
Fig. 14
Fig. 15
appears on the display
appears
Fig. 16
OFF
17