Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
O R I G I N A L I N S T R U C T I O N
Loading the Tool
•
Connect the air supply to the tool.
•
Open Tail Jaws 32 which grip the mandrel, by switching off the tail jaw switch (items 18 and 19).
•
Screw selected nose jaws onto Barrel 44 of the tool.
•*
Insert a mandrel into the tail end of the fasteners through the paper pod.
•
Slide the mandrel follower spring onto the mandrel ensuring correct orientation.
•
Gripping the tail end of the mandrel, tear off the paper pod from around the fasteners.
•
Open the nose jaws either by rotating the outer ring on Cam operated jaws or by pushing outwards on the jaw ends, as
illustrated below left.
•
Insert the previously assembled mandrel, mandrel follower spring and fasteners into the nose jaws until the first
fastener to be placed is protruding from the nose jaw.
•
Close the nose jaws and adjust so that the first fastener protrudes by 1.5mm - 3mm (1/16" to 1/8"), as shown in the
illustration below right.
•
Close the Tail Jaws 32 to ensure the mandrel is gripped, by switching on the tail jaw switch (items 18 and 19).
Re-loading the Tool
Open Tail Jaws 32 of tool, by switching off the tail jaws (items 18 and 19).
•
•
Open the nose jaws and pull the empty mandrel and mandrel follower spring out of the tool.
•
Reload the tool by following the above instructions, starting at stage •*.
Setting the Tool - Adjustable Nose Assemblies Only
Insert the previously assembled mandrel (see Loading the Tool •*) or the disposable mandrel against the stop within the Tail
Jaw Piston Assembly 60.
While holding the mandrel, close the Tail Jaws 32, which grip the mandrel, by switching on the tail jaw switch (18 and 19).
Screw the lock nut onto the Barrel 44 of the tool.
Rotate the nose assembly onto the Barrel 44.
Adjust the nose assembly so that the first fastener protrudes by 1,5mm-3mm (1/16"-1/8"), as shown in the illustration on page 11.
Tighten the lock nut against the nose assembly to prevent the nose jaw assembly from moving.
Item numbers in bold refer to the general assembly and parts list for the 07536-02200 Tool on pages 18-19.
1.5mm - 3mm
1 /16
1 /8
(
" -
")
E N G L I S H
11
Publicité
Table des Matières
