Air Cursors; Important; Loading And Reloading The Tool - Stanley 07536 Manuel D'instructions Et D'entretien

E N G L I S H

4.2 AIR CURSORS

Air Cursor Selection
See separate data sheet 07900-00863 for nose assembly components.
CURSOR
If fitted incorrectly, the cursor will not allow the loading of the tool and feeding of the fasteners.
While the cursor will be fitted the correct way round when the tool is supplied, we recommend that you check its orientation
before fitting the nose equipment. The slightly concave end of the cursor should point towards the front of the tool as
shown in the illustration.
To reverse the orientation of the cursor, follow these steps:
Extreme caution must be exercised whe undertaking the following procedure. Care must be taken to avoid the barrel and
protruding mandrel.
• Remove the Nose Assembly if there is one.
• Insert an empty mandrel fully into the tool.
• Close the Tail Jaws 32, by switching on the tail jaw switch
(items 18 and 19).
• The cursor will pop out of the barrel after a short delay.
• Open the Tail Jaws 32, by switching off the tail jaw switch
(items 18 and 19), this will release the mandrel.
• Remove the cursor from the mandrel and insert the cursor
into the barrel.

4.3 LOADING AND RELOADING THE TOOL

The procedure for loading the tool and for fitting the nose equipment to the tool is integral.
When ordering a complete tool or system you will normally be supplied with all the nose equipment required for the
fastener to be placed.
If you have been supplied with a nose jaw, mandrels and mandrel follower springs proceed with loading the tool and fitting
the nose equipment as shown below.
Item numbers in bold refer to the general assembly and parts list for the 07536-02200 Tool on pages 18-19.
10
TOOL
BARREL

IMPORTANT

CONCAVE END
IMPORTANT
O R I G I N A L I N S T R U C T I O N
CURSOR
NOSE
JAWS
CURSOR
NOSE
JAWS
TOOL
BARREL