Maintenance; Dismantling 07536-02200 - Stanley 07536 Manuel D'instructions Et D'entretien

E N G L I S H

6. MAINTENANCE

Every 500,000 cycles the tool should be completely dismantled and new components should be used where worn, damaged
or when recommended. All 'O' rings and seals should be renewed and lubricated with Moly Lithium grease EP 3753 before
assembling.
The employer is responsible for ensuring that tool maintenance instructions are given to the appropriate personnel.
The operator should not be involved in maintenance or repair of the tool unless properly trained.
The airline must be disconnected before any servicing or dismantling is attempted, unless specifically instructed otherwise.
It is recommended that any dismantling operation be carried out in clean conditions.
Prior to dismantling the tool, you will need to remove the nose equipment.
For total tool servicing we advise that you proceed with the dismantling of sub-assemblies in the order shown below
after having disconnected the hydraulic hose from the intensifier unit, air lines from the intensifier and control box, thus
separating the pistol unit from the intensifier unit.
The potentially dangerous substances that could have deposited on the machine as a result of work processes must be
removed before maintenance.

6.1 DISMANTLING 07536-02200

TAIL JAW CYLINDER
Manually flip the retaining Clip 53 up and remove the End Cap 59.
•
Using an Allen Key*, remove one Cap Head Screw 6 ensuring that any trapped air in the tail jaw cylinder is exhausted.
•
Remove the second Cap Head Screw 6.
• Pull out Rear Plug 50. Note: To aid extraction there is a 5mm thread on the rear face of the plug.
Extract air tail jaw components, comprising Tail Jaw Piston Assembly 60, Stop 52, 'O' Ring 12 and Jaws 32.
•
• Extract the remaining components, comprising of Spring 36 and Jaw Housing 42.
Free length of spring 36 should be 38.1mm (1.5"). Replace if necessary.
•
Remove piston assembly seal 'O' Ring 11.
•
• Disconnect Air Cursor Concertina Tube (Green) 49 from Elbow Connector 22.
Disconnect Air Cursor Concertina Tube (Silver) 38 from Barb Elbow 30.
•
Using an Allen Key*, remove all five handle moulding securing Screws 3, 4 and all four Nuts 8 from the tool handle.
•
• Grip Barrel 44 in a vice using soft jaws* to avoid damage.
Using a box spanner*, unscrew Barrel Plug 46, preventing Barrel 44 turning by using an open ended spanner*.
•
• Pull the Tail Jaw Cylinder 47 from the tool.
Remove 'O' Ring 14, Rubbing Strip 41 and Barrel Return Spring 37.
•
Coat the face of Tail Jaws 32 with Moly Lithium grease, in contact with Jaw Housing 42, before assembling.
•
• Assemble in reverse order of dismantling.
HYDRAULIC PISTON
Remove Tail Jaw Cylinder 47 as described earlier.
•
• Grip Body 45 in vice using soft jaws* to avoid damage, undo Stroke Limiter 40.
Using an Allen Key*, loosen Screw 5 that is clamping the Switch Block 54 to the barrel 44.
•
* Refers to items included in the 0753 Mkll Service Kit. For complete list see page 14.
Item numbers in bold refer to the general assemblies and parts lists on pages 18-19.
16
IMPORTANT
Safety Instructions appear on page 4.
O R I G I N A L I N S T R U C T I O N