Fitting Instructions - R&G CP0316 Instructions

Page | 4
PICTURE 5

FITTING INSTRUCTIONS

Near side (left side as you sit on bike)

Remove the left hand side fairing (ensuring to disconnect the indicators).

Remove the engine/frame bolts in position arrowed in picture 1 (using 10mm allen key). The bolt
at the front is secured with a nut at the rear. (The button head bolt at the rear must be reused on
assembly). Use a 14mm spanner as shown in picture 2.

Slide one of the 10mm washers (item 4) onto the M10 hexagon headed bolt (item 3=120mm long)
so washer sits against head of the bolt as shown in picture 4.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 3
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com Email:
PICTURE 4
PICTURE 6
info@rg-racing.com