R&G CP0355BL Instructions De Montage

Masquer les pouces

page de 6

/ 6
Signets

Les langues disponibles

Liens rapides

Télécharger ce manuel

FITTING INSTRUCTIONS FOR CP0355BL CRASH PROTECTORS

Page | 1

THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW.

DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT.

Please note that the way the kit is packed does not necessarily represent the way of

Please note that in cases where kits are packed with rubber washers holding the components

HE PARTS SHOWN MAY BE REPRESENTATIVE ONLY

Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ

Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301

YAMAHA MT 09 2013-

PICTURE A

REAR OF BIKE

PICTURE C

mounting to the bike

onto the bolt – the rubber washers should be thrown away!

R&G Racing

PICTURE B

FRONT OF BIKE

(

FOR CLARITY OF INSTRUCTIONS ONLY

www.rg-racing.com

Email:

)

info@rg-racing.com

Sommaire des Matières pour R&G CP0355BL

Page 1 FITTING INSTRUCTIONS FOR CP0355BL CRASH PROTECTORS YAMAHA MT 09 2013- Page | 1 PICTURE A PICTURE B REAR OF BIKE FRONT OF BIKE PICTURE C THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW. DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT.
Page 2: Tools Required
Page | 2 LEFT RIGHT TOOLS REQUIRED  Socket set to include 17mm socket and wrench.  Socket set to include 8mm A/F socket and wrench.  Torque wrench (up to 40 Nm). LEGEND ITEM 1 = BC0002 CRASH PROTECTOR CAPS (x2). ITEM 2 = B0061 with CS341 (10mm) (CRASH PROTECTORS) (x2).
Page 3 IN PICTURE ‘C’ WITH BIGGER END TOWARD FRONT OF BIKE. Turn a little more so that you feel the compression increase slightly. Then apply a quarter turn. Do not over tighten as damage can occur to the bike. Do not exceed 40nm of torque. ...
Page 4 INSTRUCTIONS DE MONTAGE POUR CP0355BL PROTECTIONS CRASH YAMAHA MT 09 2013- Page | 4 PHOTO A PHOTO B ARRIÈRE MOTO AVANT MOTO PHOTO C E KIT CONTIENT LES ARTICLES EXPOSES CI DESSOUS VERIFIER QUE TOUTES LES PIECES SOIENT PRESENTES AVANT DE PROCEDER AU MONTAGE A FAÇON DONT LE KIT EST EMBALLE NE CORRESPOND PAS FORCEMENT A LA FAÇON DE MONTER LES PIECES...
Page 5 Page | 5 GAUCHE DROITE TOOLS REQUIRED  Jeu de clés 17mm.  Jeu de clés 8mm.  Clé dynamométrique (à 40 Nm). LEGENDE ARTICLE 1 = BC0002 CAPUCHONS DE PROTECTION CRASH (x2). ARTICLE 2 = B0061 avec CS341 (10mm) (PROTECTIONS CRASH) (x2). ARTICLE 3 = S0366 ENTRETOISES (x2).
Page 6  Monter l’ensemble de protection sur le cadre et commencer à serrer le boulon (Photo A).  Serrez les boulons jusqu’à ce que vous sentiez une légère compression de l’intérieur de la protection, à l’aide d’une clé de 17 mm. LA PROTECTION DOIT ETRE POSITIONNEE COMME EN “C”...