Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
(3) First pull the Trigger.
Next, depress the Push Lever against the wood.
THE NAILER MUST NOT OPERATE.
(4) Without touching the Trigger, depress the Push Lever
against the wood.
Next, pull the Trigger.
THE NAILER MUST OPERATE.
ADJUSTING AIR PRESSURE
WARNING
Adjust the air pressure at recommended operating
pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm
according to the length of nails and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.
LOADING NAILS
WARNING
When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Grip the nail guide and knob with fi nger.
Pull the knob down and swing the nail guide open.
And open the magazine cover.
Knob
Nail guide
14
000Book̲NV75AN̲US.indb 14
000Book̲NV75AN̲US.indb 14
(2) Adjust the position of the plate according to the nail
Do not exceed
120 psi (8.3 bar
8.5 kgf/cm
).
2
)
2
(3) Place the nail coil into the magazine.
Magazine cover
length.
The nail will not feed smoothly if the plate is not
correctly adjusted.
Magazine cover
Magazine Nail holder
NOTE: Before loading nails in the magazine, adjust
the plate. If the magazine cover is forcibly
closed without adjusting the plate correctly,
the nail holder may be damaged.
1 Slide in vertical direction possible.
Lift or lower the nail holder to accept di erent
length nails.
2 Adjust the plate to the nail length reference points
on the magazine cover and turn the nail holder 45
degrees.
1
2
Magazine
Nail holder
Uncoil enough nails to reach the driving hole.
Nail holder
Nails
Magazine
3
1
/
", 2"
4
1
1
2
/
", 2
/
"
4
2
3"
2018/03/22 15:46:39
2018/03/22 15:46:39
Publicité
Table des Matières
