WAGNER EASYROLL Mode D'emploi page 12

EN
4. Lever the two caps out of the roller cover using the roller handle. (Fig. 10).
5. Push the inner roller out of the roller cover. (Fig. 11).
6. Clean the roller cover, inner roller and caps with water.
7. Clean the fill tube, roller arm and fill valve in sequence by immersing the components
in a bucket of water and moving the piston rod back and forth around 5 times. (Fig.
12, 13 and 14)
STORAGE
1. Turn the locking collar next to the trigger counterclockwise (fig. 15) until the main
tube slides off the plunger.
2. Pack a generous amount of petroleum jelly around and in between the O-rings on the
plunger. (Fig. 16)
3. Clean and pack a generous amount of petroleum jelly on the indicated bearing areas
of the arm. (Fig. 17)
4. Grease the two caps and put the roller cover and roller arm back together. (Fig. 18)
PROBLEM
A. There is paint
leakage on the roller
arm assembly
B. Plunger is difficult to
pull/push
C. The fill tube will not
fill with paint or paint
leaks from fill valve
6
CAUSE
1) The seal on the arm is
backward
2) Parts or connecting points of
the roller not properly cleaned
3) Paint residue on connecting
areas
4) The roller cover is worn or
damaged
5) The inner roller or sealing cap
is worn or damaged
6) The bearing areas are worn
1) O-rings are not lubricated
1) Paint residue on fill valve
components
EasyRoll
SOLUTION
1) Turn the seal around
2) Clean and properly
lubricate (see "Cleanup"
and "Storage" sections)
3) Clean connecting areas
4) Replace roller cover
5) Replace the inner roller
or sealing cap
6) Call customer service
1) Lubricate the O-rings on
the plunger
1) Insert fill tube firmly into
fill valve and twist fill tube
several times to break up
paint residue.
2) If the problem persists,
refer to the steps below
to clean the fill valve
components.