WAGNER EASYROLL Mode D'emploi page 13

EasyRoll
a
b
c
Item Description
1,3,5 Roller core and cap
2 Roller cover 12 mm
Roller cover 20 mm (accessories)
4 Roller arm
6,7,8 Locking cap, retainer disk, duckbill valve
9 O-ring
10 Suction system
NOTICE: If after extended use you find the plunger difficult to pull
while filling, apply a generous amount of petroleum jelly around
the o-rings located at the end of the plunger. We have included
a packet of petroleum jelly for you convenience.
Important Note regarding Product Liability!
Due to an EC ordinance in effect since 01.01.1990, the manufacturer is liable for his product
only if all parts originate from or were approved by the manufacturer and the devices
are assembled and operated correctly. The use of other accessories and spare parts can
partially or completely invalidate the liability.
1) Unscrew the locking cap (a) on the valve housing
by turning counterclockwise.
2) Remove the retaining disk (b) and the duckbill valve
(c) from the valve housing
3) Clean these parts thoroughly using water.
4) Allow all parts to dry before reassembling.
5) Grease the tip of the rubber valve (c) with Vaseline.
6) Replace the duckbill valve (c) and retainer disk (b).
7) Screw the locking cap (a) on the valve housing by
turning it counterclockwise.
Parts List (Fig. 19)
Part No. Qty.
2422071
0998230
0245717
2422073
2325721
2326966
2423178
EN
1
1
1
1
1
2
1
7