Zanussi ZOB 365 Notice D'utilisation page 24

Cleaning the oven door
The oven door has two panels of glass. You can remove
the oven door and the internal panel of glass to clean it.
The oven door can close if you try to remove the
internal panel of glass before you remove the
oven door.
1
Open the door fully
and hold the two door
hinges.
3
Close the oven door
to the first opening posi-
tion (halfway). Then pull
forward and remove the
door from its seat.
5
Release the locking
system to remove the in-
ternal panel of glass.
24
All manuals and user guides at all-guides.com
2
Lift and turn the levers
on the two hinges.
4
Put the door on a soft
cloth on a stable surface.
90°
6 Turn the two fasteners
by 90° and remove them
from their seats.
2
1
7
Carefully lift (step 1)
and remove (step 2) the
panel of glass.
Clean the glass panel with water and soap. Dry the
glass panel carefully.
Installing the door and the glass panel
When you install the panel with a decorative frame,
make sure that the screen-printing zone looks to the in-
ner side of the door. Make sure that after the installation
the surface of the glass panel frame on the screen-print-
ing zones is not rough when you touch it.
Make sure that you install the internal panel of glass in
the seats correctly (refer to the illustration).
Oven lamp
Warning! Be careful! There is the risk of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the
circuit breaker.
Put a cloth on the bottom of the oven for protec-
tion of the oven light and glass cover.
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C
heat-resistant oven light bulb.