Publicité
This publication governs all warranty labor allowances for 2003 Bombardier Personal Watercraft.
1. HOW DOES IT WORK
We follow the procedures detailed in the Bombardier Watercrafts Shop Manual. The flat rate time is the maximum
time allowed for a repair involving any given part. FLAT RATE TIME IS NOT CUMULATIVE. You must use the flat
rate time given for the longest lasting operation.
NOTE: The Flat Rate Time Schedule was prepared by skilled mechanics using the hand tool usually found in work-
shops and all the special tools mentioned in the Shop Manual.
2. COMPILATION
The Flat Rate Time Schedule is compiled as follows:
The actual required time to perform the repair plus (+) 30% correction factor up to 3.0 hours or (+) 15% over 3.0
hours time to take into account, among others:
– vehicle handling
– obtaining the parts
– diagnosis
– cleaning
– special compensation (rusted bolts)
3. HOW TO USE IT
Refer to the system you need, locate part of series of parts replaced. List JOB CODE in the appropriate column on
claim.
SYSTEM
01
ENGINE
CARBURETOR AND OIL INJECTION
02
SYSTEM
03
IGNITION
04
STARTER
NOTE: Unless otherwise specified, dismantling order is: top to bottom, exterior to interior, front to rear.
All fractions of hours are in tenths:
0.1 = 6 minutes
0.2 = 12 minutes, and so on
LEGEND:
* REQUIRES PRIOR AUTHORIZATION BY DISTRIBUTOR.
** INDICATE LABOUR TIME ON LINE "LABOUR ONLY" OF CLAIM.
*** INDICATE $$$ AMOUNT ON "SUB-CONTRACTED LABOUR" OF CLAIM.
IMPORTANT: Always use the longuest flat rate time applicable to the repair performed.
4. JOB REQUIREMENTS
All the flat rate times mentioned in the following pages include the required operations such as: engine timing,
connecting rod(s) alignment, cylinder head(s) torque or use of parallel bar, use of ignition tester, piston clearance/ring
end gap measurement, crankshaft to crankcase measurement, cylinder honing, engine leak test.
5. ILLUSTRATIONS
The illustrations contained in this manual do not necessarily show every components of a given system as Parts
Catalog do. Their purpose is to facilitate recognition of parts related to a flat rate time. Item numbers on illustrations
correspond to the four or five digit Job Code.
6. SUGGESTION (FORM REQUEST)
Volume 2
INTRODUCTION
PAGE
SYSTEM
4
05
07
21
09
29
10
32
11
2003
PROPULSION
STEERING AND CONTROLS
BODY
ELECTRICAL SYSTEM
CLAIM TYPE 02
PAGE
35
41
45
53
55
1
STF2003_001.FM
Publicité
