Bitzer ST-140-1 Mode D'emploi page 75

10 Selecting the oil cooler with the BITZER SOFTWARE
The design in the software is based on the discharge gas temperature. Discharge gas temperature or oil cooler
outlet temperature (= oil injection temperature) are then thermostatically controlled ( Thermostatic control of the oil
cooler ).
A design with frequency inverter is also possible with the BITZER SOFTWARE - or available on request by
BITZER.
NOTICE
!
!
Oil cooler capacity at part load may be higher than at full load.
This has to be taken into account when designing the oil cooler (consult with BITZER if necessary).
As an example, a selection for HS. compressors is described below. The same applies to CS. compressors.
ST-140-1 // PDF Download 75