Replacing The Depth Wheel; Replacing The Skirt; Replacing The Cutting Blade - Stihl FBD-KM Notice D'emploi

English

Replacing the Depth Wheel

Have a worn depth wheel replaced by a
servicing dealer. STIHL recommends
that you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
1
2
The end of the thread on the
N
screw (1) is peened over to ensure
that the wingnut (2) does not work
loose and be lost.
A very high torque has to be applied to
remove the wingnut from the screw. If
the parts are then reassembled, the
captive function is no longer
guaranteed. In such a case have the
screw and wingnut replaced by a
servicing dealer.
12

Replacing the Skirt

Removing the skirt
2
1
3
Take out the screws (1).
N
Remove the strap (2) and skirt (3).
N
Fitting the skirt
2
1
3
Place the skirt (3) in position – it
N
must be flush with the end of the
deflector.
Fit the strap (2), insert the
N
screws (1) and tighten them down
firmly.

Replacing the Cutting Blade

STIHL recommends the use of only
genuine STIHL blades – see "Special
accessories".
1
WARNING
A worn, bent or cracked blade (1) must
not be straightened or welded – it may
break completely! – always install a new
blade.
WARNING
Do not resharpen the blade!
Check for signs of wear
To determine the existing wear, check
the corner (arrow) of the blade and along
the edge of the cutter blades.
FBD-KM