Mounting The Multitool - Stihl FC-MM Notice D'emploi

English

Mounting the MultiTool

Removing Existing MultiTools
WARNING
Wear gloves to reduce the risk of injury
from contact with sharp MultiTools
and/or hot surface of gearbox.
Remove the hitch pins and pull the
N
MultiTools (if fitted) off the axle –
see also "Mounting the MultiTool" in
the instruction manual of the other
MultiTool.
Clean the gearbox if necessary.
N
Checking Position of Gearbox
WARNING
To reduce risk of injury from the
MultiTool rotating in the wrong direction,
check that position of gearbox is correct
and adjust if necessary.
8
1
3
The axle (1) must be below the shaft (2).
Direction of rotation (3) of MultiTool.
Adjusting Position of Gearbox
Loosen clamp screws on gearbox.
N
Turn the gearbox through 180°.
N
Line up the gearbox in the correct
N
position.
Tighten down the two clamp screws
N
on the gearbox in the following
sequence:
Tighten the first screw moderately.
–
Tighten the second screw
–
moderately.
Tighten down first screw firmly.
–
Tighten down second screw firmly.
–
2
NOTICE
It must not be possible to rotate the
gearbox on the drive tube.
Mounting the MultiTool
The direction of rotation is marked with
arrows on the gearbox and cutting
blade. Make sure the arrows point in the
same direction.
8
4
5
Fit the two sleeves (4) on the right
N
and left.
Rotate the blade (5) on the right-
N
hand axle (viewed from engine) until
it can be pushed into position –
check the direction of rotation again
(arrows).
Push the wheel (6) and washer (7)
N
onto the left-hand axle (viewed from
engine).
Insert and engage both hitch
N
pins (8) in the holes in the axles –
fold the hitch pins flat against the
blade and wheel.
8
6
4
7
FC-MM