Replacing The Batteries - Mission Hb Mode D'emploi

Replacing the Batteries

When the battery icon is flashing, the battery
is running low and should be replaced as soon as
possible. An E-4 error message will appear if the
battery is too low to perform any more tests. The
meter will not function until the battery is replaced.
Make sure the meter is off before removing the battery. Turn the meter
over to locate the battery cover. Press the battery cover tab on the top and
lift the cover to open it. Remove and discard the old batteries. Insert three
AAA batteries on top of the plastic tape. Make sure the two outside
batteries are aligned with the plus ( + ) side down, towards the bottom of the
meter, with the middle battery aligned with the plus ( + ) side facing up,
towards the top of the meter.
Close the battery cover and make sure that it snaps shut. Recheck and
reset the clock setting as necessary after battery replacement to ensure time
is set correctly. Refer to Section 4 Initial Setup.
Note: Do not discard batteries along with household waste. Follow
local regulations for disposal.
39