Mission Hb Mode D'emploi page 89

Section 8
Optical Check
Press ◄ or ► from the Setup Screen to select the Optical Check mode as
shown.
Note:
•
The control strip is intended for checking the optical system.
Refer to Section 9 Quality Control Test for using control solutions.
•
Allow the strips and the meter to reach room temperature
(15-30ºC or 59-86ºF) prior to testing.
•
The optical check should be performed under normal lab lighting
conditions. Do not perform under sunlight or extreme lighting
conditions.
Press to enter this mode. The meter will flash the strip symbol as
shown below.
Optical System Check
34