Mission Hb Mode D'emploi page 69

Coding the Meter
Each time a new box of test strips is used, the code chip packaged with the
new box of test strips must be inserted into the meter. Take the code chip
from the test strip box. Compare the code number on the code chip with
the code number printed on the test strip canister label. Results may be
inaccurate if the two numbers are not identical. For US customers,
immediately call customer service toll free at 1-(800)-838-9502 if the code
number on the code chip does not match the number on the test strip
canister with which it was packaged. For customers outside the US,
contact your local distributor immediately.
Insert the new code chip into the code chip slot of the meter. It should
easily snap into place. The code chip should remain in the meter. Do not
take it out until a new box of test strips is needed. The code number will
appear on the Initial Screen after startup.
For US Customers, immediately call customer service toll free at
1-(800)-838-9502 if the code number on the code chip does not match the
number that is displayed on the screen. For customers outside the US,
contact your local distributor immediately.
If the code chip is not properly inserted into the code chip slot, or if it is
missing, the meter will display three dashes as shown below.
14