Mission Hb Mode D'emploi page 92

Section 10 Maintenance
Proper maintenance is recommended for best results.
Cleaning
For best results, the meter should be cleaned after each day of testing.
Meter Surface
A cotton cloth can be used to clean the surface of the meter. Use a damp
cotton cloth if necessary.
A dry, soft cloth may be used to clean the LCD and the sensor area. It is
recommended that the meter be stored in the carrying case after each use.
Take care to avoid getting liquids, residue, or control solutions in the meter
through the Strip Channel, Code Chip Slot or USB Port.
Test Strip Holder
Remove the Test Strip Holder by pressing in on middle of the Test Strip
Holder and sliding it out from the meter. Wipe it with a damp cloth or a mild
detergent and dry it with a dry, soft cloth. Slide the Test Strip Holder back
into the meter by laying it flat on the meter. Firmly press down on the
center of the Test Strip Holder with your thumb and push it in until it clicks
into place.
Note: Do not use organic solvents, such as gasoline or paint thinner.
This will cause damage to the meter.
37