Yamaha mLAN8P Mode D'emploi page 33

C
[MIDI/UTILITY] - [SYS]
Follow the steps below to make system-related settings.
1. Press the [MIDI/UTILITY] button.
2. Press the [SYS] button.
3. Use the [ PAGE
4. Use the [+1/ENTER] and [–1/EXIT] buttons or the [VALUE] dial to select the names of the
devices and parameter values.
[Digital Input Source]
This parameter is used to select "Optical" or "Coaxial" on the mLAN8P's rear panel to input
Digital In signals.
Value: Optical, Coaxial
When "Optical" is selected:
[Digital/Analog Output Source]
This parameter is used to select signals output to ANALOG OUT and Digital Out on the rear
panel.
Value: Stereo Mix, AUX 1/2, Digital In, A/D In
When "Stereo Mix" is selected:
NOTE
The signal assigned to ANALOG OUT is also output to the headphones
(PHONES).
] button to select a parameter you wish to set.
Mode Functions
33