Installing The Upper Section - Kessel Pumpfix F SPZ 1000 Mode D'emploi

5.6

Installing the upper section

Depending on installation depth, the upper section (1)
(insertion depth of the upper section) may have to be cut to
length or have recesses (4) made in it for the cable connec-
tions, which are fed into the side of the drain body (3).
The upper section (1) may only be extended by a maxi-
mum of 2 extension sections, so that it remains possible
to reach into the drain body for maintenance purposes.
Insert the seal (2) grease-free into the groove on the
drain body (3).
Grease the sealing lips of the seal (2) (A).
Push the upper section (1) into the drain body and align
it.
5.7 Fitting the cover plate
The cover plate is mounted to protect against dirt ingress,
e.g. building material.
Keep the sealing area clean.
Fit the seal on the cover plate from below.
Grease the seal on the outside.
Insert the cover plate (1) in the upper section (3).
Close both cover fasteners (2).
010-843 Installation and operating instructions 27 / 96