Declaration Of Conformity - Rubi TC-125 Notice Originale

Adjustment of the eccentric bearings
77. There are only two wheels for adjusting the play of the
cutting head (see image). (Fig. X-22)
78. Block rotation of the screw with a flat-head
screwdriver while loosening the nut with a 10 mm flat
spanner in a counter-clockwise direction (tools not
included). (Fig. X)
79. Turn the screw until the wheel makes contact with the
guide. (Fig. Y)
NOTE: More pressure reduces the smoothness of sliding
and the amount of play. Less pressure increases the
smoothness of sliding, but also the amount of play.
The perfect adjustment is the balance between the
two configurations.
80. Hold the screw and at the same time tighten the nut in
a clockwise direction. (Fig. Z)
81. Check that the correct amount of play has been set.
Repeat the above procedure if necessary.
Storage
Store the tool in its packaging in a cool, dry place
protected against cold and direct sunlight.
The machine must be put out of service and
dismantled in accordance with the instructions in
each country, at a selective collection point for the
proper classification and processing of the materials.
After-sales service
Use only original spare parts supplied by the
manufacturer. Repairs should only be done by
certified workshops or RUBI's technical service:
www.rubi.com
Tel: +34 93 680 65 00
gboada@rubi.com

4.- DECLARATION OF CONFORMITY

The company, Germans Boada S.A Avda. Olimpíades 89-
91, P.O Box 14 -08191 Rubi (Barcelona, Spain), declares,
under its sole responsibility, that the machine:
TC-125
Complies with the following standards:
• EN ISO12100:2010
• EN 60745-1:2009+A11:2010
• EN 60745-2-22:2011+A11:2013
• EN 60204-1:2006/AC:2010
• EN 55014-1:2006/A2:2011
• EN 55014-2:1997/A2:2008
And complies with the essential requirements of the fo-
llowing directives:
• DIRECTIVE 2006/42/EC
• DIRECTIVE 2014/30/EU
• DIRECTIVE 2014/35/EU
Rubï, 01/02/2019
Carles Gamisans Berenguer
Director I+D
English
TRANSLATION OF THE ORIGINAL
TECHNICAL CHARACTERISTICS...............................Page 146
ACCESSORIES.........................................................Page 147
ELECTRICAL CIRCUIT...............................................Page 153
GUARANTEE...........................................................Page 158
The reproduction of the work, in whole or in part, in any format or by any means
or procedure, whether mechanical, photographic or electronic, without the prior
authorisation of GERMANS BOADA, S.A. is prohibited.
Any of these activities shall incur the corresponding legal liabilities and could result
in criminal prosecution.
GERMANS BOADA, S.A. reserves the right to make any technical modification
without prior notice.
15.