Hendi 210000 Mode D'emploi page 7

• Attach the hand guard.
1. Place both screws in
the carriage.
NOTE! You are advised not to use the appliance if the hand guard is not attached as instructed! These are
safety features that will prevent possible injury. If you do not attach these features, there will be a risk of
injury.
Instructions for use
• Position the appliance so that the on/off switch is
facing the user.
• If the blade sharpener has not been installed,
proceed as follows:
- Position the blade sharpener in its support so
that the blade does not extend between the
gears.
- Tighten the safety screw on the blade sharpen-
er.
- Note! The appliance is equipped with a safe-
ty switch and will turn off automatically if the
sharpening device is removed)
• Push the plug in the wall socket.
2. Attach the hand
guard.
3. Place the two wash-
ers over the white
bolts.
• Turn the dial with the graduated scale to the de-
sired slice thickness.
• Switch ON the appliance by pressing the "WHITE
(I)" button of the ON/OFF switch.
• Put the food product on the carriage and adjust
the clamp to hold the product firmly in place.
Make sure the product is positioned against the
stop plate.
• Once the product has been sliced, switch OFF the
appliance by pressing the "BLACK (O)" button of
the ON/OFF switch.
• Turn the thickness dial back to "0".
4. Screw on the two
dome nuts.
7
EN