Hendi 210000 Mode D'emploi page 6

Main parts of the appliance
1 Blade sharpener
2 Stop plate
3 Carriage
4 On/off switch
[White (I): ON; Black (O): OFF]
5 Slice thickness dial
6 Product clamp
7 Blade guard
8 Blade
9 Carriage lock
10 Blade guard bolt (not displayed)
Preparations before using for the first time
• Check to make sure no parts are missing. If any
parts are missing, contact your supplier.
• Remove all the packing material.
• Keep the packaging if you intend to store your ap-
pliance in the future.
EN
• Check the appliance for completeness and trans-
port damages. In case of incomplete delivery or
damage, contact supplier immediately. DO NOT
use the appliance. (See ==> Warranty).
1. Top view of the appliance
NOTE! The sharpening device is equipped with a safety switch. If the sharpening device is not properly at-
tached, you will not be able to use the appliance.
6
• Clean the blade. Be careful: the blade is very
sharp. (Use gloves if necessary, not included)
• Keep open a space of at least 10 cm around the
appliance to allow for adequate ventilation.
• Position the appliance in such a way that the plug
is always accessible.
• If the sharpening device is not attached, proceed
as follows:
2. Attach the sharpening module
in such a way that the blade
does not move between the
wheels.
9
3. Secure the sharpening device
to the machine by tightening
the holder. Check to make
sure that the sharpening de-
vice is well secured before us-
ing the machine.