Hendi 210000 Mode D'emploi page 12

Power supply cord
Periodically check the power supply cord for any symptoms of worn-out and, if this is the case, please call the
"SERVICE CENTER" to have it replaced.
Blade
Check that the blade does not lose more than 10mm of its original diameter. To have it replaced call the
"SERVICE CENTER".
Sharpener - grinding moles
Check that the grinding moles retain their abrasive property during sharpening operations. Call the "SERVICE
CENTRE" if it is necessary to replace the grinding moles to prevent the blade damage.
Lubrication of sliding guides
From time to time pou some oil drops onto the round sliding guide along which the carriage moves back and
forth. This operation can be performed through the opening (OIL) next to the dial knob.
Label of the push-button panel
If the labels of the push-button panel have been damaged, call the "SERVICE CENTER" for replacement.
Machine disposal
Putting the machine out of service
If for some reason there is a necessity to put the
machine out of service, make sure nobody can use
EN
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
Troubleshooting
If the appliance does not function properly, please check the below table for the solution. If you are still
unable to solve the problem, please contact the supplier/service provider.
Problem
Appliance does not
slice evenly
Appliance stops
slicing
Carriage does not
slide
Blade stops when
product is being cut
When in doubt, always contact your supplier!
12
Possible cause
Blunt blade
Dirty appliance
Overheated motor
Dirty slide bar
Some food stick to the
blade.
v-belt worn out or dirty Contact the supplier.
it: disconnect it from the mains and eliminate any
the electrical connections.
• Store the appliance in a cool, clean and dry place.
Solution
Sharpen blade
Clean the appliance
Let the machine cool off for an extended period. The
motor's safety thermostat will reset itself automatically.
Clean the slide bar and lubricate with Vaseline
Switch off the appliance & unplug it. Let it come to a
complete stop. Remove any blockage. Wipe the blade
with a damp cloth.