Manufacturer's Warranty - Hilti VC 20-U Mode D'emploi Original

Trouble or fault
The motor doesn't restart.
The motor doesn't run when
set to "AUTO".
The automatic filter element
cleaning system doesn't
work.
9 Disposal
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
In accordance with the European Directive on waste electrical and electronic equipment and its implemen-
tation in conformance with national law, electric tools or appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
▶ Do not dispose of electric appliances together with household waste.
Drilling slurry
Disposal of drilling slurry directly into rivers, lakes or the sewerage system without suitable pretreatment
presents environmental problems.
▶ Ask the local public authorities for information about current regulations.
We recommend the following pretreatment:
▶ Collect the drilling slurry (for example, using a wet-type vacuum cleaner).
▶ Allow the drilling slurry to settle and dispose of the solid material at a construction waste disposal site
(addition of a flocculent may accelerate the settling process).
▶ The remaining water (alkaline, pH value greater than 7) must be neutralized by the addition of an acidic
neutralizing agent or diluted with a large volume of water before it is allowed to flow into the sewerage
system.
Drilling dust
▶ Dispose of the drilling dust collected by the vacuum cleaner in accordance with the applicable national
regulations.

10 Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
11 EC declaration of conformity
Manufacturer
Hilti Aktiengesellschaft
Feldkircherstrasse 100
9494 Schaan
Liechtenstein
We declare, on our sole responsibility, that this product complies with the following directives and standards.
Designation
32
Printed: 01.10.2015 | Doc-Nr: PUB / 5071294 / 000 / 07
All manuals and user guides at all-guides.com
Possible cause
The motor overheating protection
cut-out has been activated.
The motor overheating protection
cut-out switches the motor off re-
peatedly because the air vents are
clogged.
The appliance is faulty or is not
correctly plugged in.
No suction hose is connected.
Wet / dry vacuum cleaner
Action to be taken
▶ Switch the appliance off and
allow it to cool down for about
5 minutes.
▶ If the motor doesn't start, return
the appliance to Hilti Service.
▶ Clean the air vents carefully
using a dry brush.
▶ Make sure that the supply
cord plug is fully plugged in
and check that the appliance
functions correctly.
▶ Connect the suction hose.