Adjusting The Headrest; Securing The Child - Cybex Platinum SOLUTION Z i-FIX Mode D'emploi

Masquer les pouces Voir aussi pour SOLUTION Z i-FIX:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13

ADJUSTING THE HEADREST

The headrest (c) can be adjusted by using the headrest height adjuster (d) at the
back of the headrest (c). There are 12 height positions that can be set. Adjust
the headrest (c) so that max. 2 cm (approx. 2 finger's width) remain between the
child's shoulder and the headrest (c).
��
The height of the headrest can still be adjusted while the seat is installed in
the car.

SECURING THE CHILD

1. Route the vehicle seat belt around your child and insert the belt tongue into the
belt buckle. It must lock into place with an audible "CLICK".
2. Place the lap belt in the green coloured lap belt guides (f) of the child seat.
3. Pull the shoulder belt to tighten the lap belt.
4. On the side of the car seat next to the belt buckle, the shoulder belt and the lap
belt must be inserted together in the lap belt guide (f).
5. Feed the shoulder belt through the shoulder belt guide (g) until it is inside the
belt guide.
6. Ensure that the shoulder belt runs across your child's clavicle and does not
touch your child's neck. If necessary, adjust the height of the headrest (c) to
change the position of the belt.
REMOVING AND REATTACHING THE SEAT COVER
The cover of the child seat consists of 5 parts (2x headrest, 2x backrest and
booster). These are held in position at several places by press-studs, velcro and
elastic tapes. Once all have been released, the single parts of the cover can be
removed.
In order to put the covers back on the seat, follow the removal instructions in the
reverse order.
��
The cover may only be washed at 30 °C with a delicate wash program otherwise
it may result in discolouration of the cover fabric. Please wash the cover
separately from other laundry and do not dry in the dryer or in direct sunlight!
MANUFACTURER'S WARRANTY AND DISPOSAL REGULATIONS
CYBEX GmbH (Riedingerstr. 18, 95448 Bayreuth, Germany) gives you 3 years
warranty on this product. The warranty is valid in the country, where this product
was initially sold by a retailer to a customer. The contents of the warranty and all
essential information required for the assertion of the warranty can be found on
our homepage go.cybex-online.com/manufacturer-warranty-car-seats. If a
warranty is shown in the article description, your legal rights against us for defects
remain unaffected.
Please observe the waste disposal regulations in your country.
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Solution z-fix

Table des Matières