Cybex Platinum SOLUTION Z i-FIX Mode D'emploi page 7

CERTIFICATION
R129/03
SOLUTION Z I-FIX
CYBEX Solution Z i-Fix
100 – 150 cm
Recommended from approx.
3 years to 12 years
Thank you for deciding on the Solution Z i-Fix when choosing your child seat.
Carefully read this user guide before installing the car seat in your vehicle and
always keep it to hand in the designated user guide storage compartment (a).
IMPORTANT INFORMATION
• Without the approval of the Type Approval Authority, the child seat may not be
modified or added to in any way.
In order to keep your child properly protected, it is absolutely essential that
•
you use the child seat as described in this manual.
This child seat may only be installed on vehicle seats which are approved for
•
the use of child restraint systems according to the vehicle manual.
Only suitable for vehicle seats with automatic three-point belts approved in
•
accordance with UN regulation 16 or a comparable standard.
Do not use any load bearing contact points other than those described in the
•
instructions and marked on the child restraint.
The full surface of the backrest of the child seat must make contact with the
•
backrest of the vehicle.
The shoulder belt must run upwards and back at a recline. It must never run
•
forward to the upper belt point in your vehicle.
The vehicle belt buckle must never cross the belt guide of the seat. If the belt
•
whip is too long, the child seat is not suitable for use in this position in the
vehicle. In case of doubt please contact the child restraint manufacturer.
The three-point vehicle belt must only be passed through the designated
•
routings. The belt routings are described in detail in this manual and are
marked in green on the child seat.
The lap belt must run as low as possible across your child's groin to have
•
optimum effect in the event of an accident.
Before each use make sure that the automatic three-point vehicle belt is
•
correctly adjusted and fits tightly to the child's body. Never twist the belt!
Specific Vehicle
Booster Seat
100-150 cm
030036
UN Regulation
No. 129/03
Cybex GmbH
Riedingerstr. 18, 95448 Bayreuth
Germany
Only an optimally adjusted headrest can offer your child maximum protection
•
and comfort while ensuring that the shoulder belt can be fitted smoothly.
The child seat must always be secured correctly with the vehicle belt in the
•
vehicle even when not in use.
Always ensure that the child seat is never jammed when closing the car door
•
or adjusting the back seat.
The child seat is also tested and homologated without the Linear Side impact
•
Protectors.
Luggage or any other objects present in the vehicle must always be firmly
•
secured. Otherwise, they may be thrown within the car, which could cause
fatal injuries.
The child seat must never be used without the seat cover. Ensure that only
•
an original CYBEX seat cover is used, as the cover is a key element of the
seat's function.
Never leave your child unattended in the car.
•
The parts in the child restraint system heat up in the sun and could potentially
•
burn your child's skin. Protect your child and the child seat from direct sun
exposure.
An accident may cause damage to the child seat that is not identifiable with
•
the naked eye. Please replace the seat after an accident. In case of doubt,
please consult your dealer or the manufacturer.
Do not use this child seat for more than 9 years. The child seat is exposed to
•
high stress during its product life span, which leads to changes in the quality
of the material with increasing age.
The plastic parts can be cleaned with a mild cleaning agent and warm water.
•
Never use harsh cleaning agents or bleaches!
On some vehicle seats made of sensitive materials, the use of child seats may
•
leave marks and/or cause discolouration. To prevent this, you can place a
blanket or towel or similar underneath the child seat to protect the vehicle seat.
EN
5