Frost Warning - Conrad Electronic WS55 Notice D'emploi


• When switching through the Min/Max value for display A, display B switches
respectively between Min and Max value also. However, for display B, this
simply represents the Min and Max values since Reset!
• If a storage indication is selected, the corresponding extreme value of all
sensors can be called successively for display B by briefly pressing several
times the "SENSOR" button.
• Returning to the normal display is effected as described under "Sequence
of display A" after "Max. value of previous month" ("Max Month").
Deleting stored MIN/MAX values

The stored Min/Max values of all sensors are deleted together.
• Long press the "MIN MAX" button.
• The whole display goes out and "rEs" appears in the display for 2 seconds.
• Afterwards the display goes back to the normal display, as it was before the Reset.
The current measured values are taken over immediately as new Min/Max values.
d) Switching the measured value of temperature
For display B you can switch between the display of the temperature and the corresponding
dewpoint.
• Briefly press the "SELECT" button. Display B switches between temperature and dewpoint
indicator.
• With the dewpoint indicator, the writing "Dewpoint" appears also.
e) Frost warning
The frost warning is always active and warns when the temperature of the sensor displayed
in the corresponding display field goes below the value of +4°C or +39.2°F.
If the warning state occurs with a temperature of <=4°C for the first time, the frost symbol of
the corresponding display flashes for 30 seconds then the frost symbol " " is switched on
permanently.
It is only when the temperature exceeds a value of +5°C that the frost warning switches off.
If necessary, an additional acoustic warning indicator can be activated (see chapter 11.c).
48
All manuals and user guides at all-guides.com